Rainbow-electronics ATmega128L Manuale Utente Pagina 270
- Pagina / 331
- Indice
- SEGNALIBRI
Valutato. / 5. Basato su recensioni clienti
270
ATmega128(L)
2467B–09/01
Store Program Memory
Control Register – SPMCR
The Store Program Memory Control Register contains the control bits needed to control
the Boot Loader operations.
• Bit 7 - SPMIE: SPM Interrupt Enable
When the SPMIE bit is written to one, and the I-bit in the Status Register is set (one), the
SPM ready interrupt will be enabled. The SPM ready Interrupt will be executed as long
as the SPMEN bit in the SPMCR register is cleared.
• Bit 6 - RWWSB: Read-While-Write Section Busy
When a self-programming (page erase or page write) operation to the RWW section is
initiated, the RWWSB will be set (one) by hardware. When the RWWSB bit is set, the
RWW section cannot be accessed. The RWWSB bit will be cleared if the RWWSRE bit
is written to one after a self-programming operation is completed. Alternatively the
RWWSB bit will automatically be cleared if a page load operation is initiated.
• Bit 5 - Res: Reserved Bit
This bit is a reserved bit in the ATmega128 and always read as zero.
• Bit 4 - RWWSRE: Read-While-Write Section Read Enable
When programming (page erase or page write) to the RWW section, the RWW section
is blocked for reading (the RWWSB will be set by hardware). To re-enable the RWW
section, the user software must wait until the programming is completed (SPMEN will be
cleared). Then, if the RWWSRE bit is written to one at the same time as SPMEN, the
next SPM instruction within four clock cycles re-enables the RWW section. The RWW
section cannot be re-enabled while the Flash is busy with a page erase or a page write
(SPMEN is set). If the RWWSRE bit is written while the Flash is being loaded, the Flash
load operation will abort and the data loaded will be lost.
• Bit 3 - BLBSET: Boot Lock Bit Set
If this bit is written to one at the same time as SPMEN, the next SPM instruction within
four clock cycles sets Boot Lock bits, according to the data in R0. The data in R1 and
the address in the Z pointer are ignored. The BLBSET bit will automatically be cleared
upon completion of the lock bit set, or if no SPM instruction is executed within four clock
cycles.
An LPM instruction within three cycles after BLBSET and SPMEN are set in the SPMCR
register, will read either the Lock-bits or the Fuse bits (depending on Z0 in the Z pointer)
into the destination register. See
“Reading the Fuse and Lock Bits from Software” on
page 274
for details.
• Bit 2 - PGWRT: Page Write
If this bit is written to one at the same time as SPMEN, the next SPM instruction within
four clock cycles executes page write, with the data stored in the temporary buffer. The
page address is taken from the high part of the Z pointer. The data in R1 and R0 are
ignored. The PGWRT bit will auto-clear upon completion of a page write, or if no SPM
instruction is executed within four clock cycles. The CPU is halted during the entire page
write operation if the NRWW section is addressed.
• Bit 1 - PGERS: Page Erase
If this bit is written to one at the same time as SPMEN, the next SPM instruction within
four clock cycles executes page erase. The page address is taken from the high part of
Bit 765 4 3 210
SPMIE RWWSB – RWWSRE BLBSET PGWRT PGERS SPMEN SPMCR
Read/Write R/W R R R/W R/W R/W R/W R/W
Initial value 0 0 0 0 0 0 0 0
- Features 1
- ATmega128(L) 10
- Table 55 on 95
- OCnPCPWM 96
- MAX - 1 MAX BOTTOM BOTTOM + 1 97
- 8-bit Timer/Counter 98
- Register Description 98
- “Access 107
- DATABUS (8-bit) 112
- (Toggle) 118
- OCnxPFCPWM 125
- OCRnx Value 126
- 2467B–09/01 150
- Oscillator 251
Prodotti e manuali riguardandi Sensori Rainbow-electronics ATmega128L
Sensori Rainbow-electronics AT89C5131 Manuale Utente
(175 pagine)
(175 pagine)
(14 pagine)Electrolux ESL66075R Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Nein Electrolux ESL66075R.
Wir stellen 1 PDF-Handbücher Electrolux ESL66075R zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung
Commenti su questo manuale